Features and uses of conveyor belt heat vulcanized glue and vulcanized film

This product is a high-performance adhesive composed of flame retardant vulcanizates and vulcanized films. It has the characteristics of high temperature resistance, water resistance, oil resistance, aging resistance, glue can not burn when exposed to fire, high bonding strength and so on.

This product is widely used in various rubber conveyor belts, steel core conveyor belts, whole core conveyor belts, nylon, canvas, polyester conveyor belt joints vulcanized glue, especially suitable for the above conveyor belt joints vulcanized glue in high temperature environment.

How to prevent the belt from sealing on both sides and the seal after vulcanization? Is the inner core glue fully melted?

At present, the vulcanized joints sometimes have tight straps and loose straps, which may cause serious deviation. The seals on both sides of the belt and the non-working surface are easy to open, and the inside is easy to empty. We are now using stepped lap. The sanding is also good. Nylon cloth is also cleaned with gasoline. Thin film of 0.75 thick used for core glue. The glue we use is made from gasoline and the thin film on it. Now the center line of the belt head pair is also correct. After the connection, the belt will be tight and loose, and it will run off. It is not easy to adjust. The sealing of the non-working surface will also be reinforced, but it is easy to open the glue. There are obvious marks after the two sides of the belt are connected, and the film spread on the side is squeezed out and is foamy. Is this undervoltage? Also, when we heat up to 150, sometimes the power is turned off directly to cool down, without heat preservation.